|
|
CT60 and related things BBS
| Re: CT060 update |
|---|
|
Posted by: vl60
|
Feb,17.2009-18:03
|
"Normally the cable must be attached and powered (by the CT60) for proper verification. Only SDR60 can be programmed (or verified) when the CT60 is connected to the mother board in normal 030 mode (if you use the same machine CT60/F030 ;-) ). If you update the ABE60 chip you need to remove the CT60 from the bus excepted if there are a 1Kohms resistor between GND (Ground) and the pin #1 of one of the three 74LVC245 chips. In this case the blitter must not be used (NVDI installed)."
|
[All messages in this thread] [Start new thread]
What's the anti-troll code?
That's your personal code to be able to add comments and messages on the dhs.nu site.
Don't have a code or forgot it? Fix it here.
|
